AQARA WL-S02D T1 Zigbee 3.0 water leak sensor

AQARA's newest water leak detector supporting the Zigbee 3.0 protocol, which sends an alarm when water is detected and can start automations / scenes.

If the sensor detects that the amount of water reaches 0.5 millimeters, it will send a warning to your phone or activate the alarm on the AQARA HUB to prevent damage caused by water leakage.

Thanks to the wireless and extra small design, it can be placed anywhere where water leaks may occur.

Thanks to the IP67 certification, it is also resistant to dust and water.

Properties:

- Supports Zigbee 3.0 protocol
- Power supply: with CR 2032 Battery
- Communication: Zigbee 3.0
- Frequency: 2405-4480 MHz
- Maximum output power: 13 dBm
- Operating temperature: -10°C to 55°C
- Operating humidity: 0-100% RH (without condensation)
- Sensors: water sensor
- Box contents: 1 water sensor, 1 instruction manual.

Requires Aqara Hub to operate.

Compatibility: HomeKit, Google, Alexa and IFTTT

Factory part number: WL-S02D

Description:

- Manufacturer: Aqara
- Factory article number: WL-S02D
- Plug&Play installation: Yes

Sound, image, sensor parameters

- Sensor: Water sensor

Installation / operation

- Operating power supply: Battery
- Connection: Works with batteries

Supported protocols

- Wi-Fi: No
- Zigbee: Yes, Zigbee 3.0
- Z-Wave: No
- RF / radio control: No

Remote control, smart control

- Can be controlled remotely via the Internet: Yes, e.g. when connected to an Aqara Zigbee hub
- Manufacturer smartphone app: Yes, Aqara app
- Can be switched by voice control: Yes, Google Assistant, Alexa, Siri compatible
- Cloud mode (with factory firmware): Yes, it connects to the Aqara device via the Aqara hub
- Local network mode (with factory firmware): Yes, Aqara hubs can run local automations offline

Other

- Dimensions: 5.0 × 7.0 × 9.5 cm