ANYCUBIC Wash & Cure 3 Max washing and curing system WC3M-IP-O

The Anycubic Wash & Cure 3 Max combines washing and post-curing of 3D prints in a single streamlined process. Its 14.9-liter chamber and maximum cleaning area of 300 × 165 × 300 mm make it suitable for large models and for most resin printers with a screen diagonal of up to 13.6 inches.

A dual washing system combines spray and immersion modes to remove resin residue from the surface of a model as well as from hard-to-reach details. According to the manufacturer, alcohol consumption is more than 50 percent lower than with conventional solutions, with less than 50 ml used per cycle.

Post-curing takes place on an automatically rotating platform that exposes all sides of the model evenly. With an output of 25,000 µW/cm² and one-click start for the whole washing and curing sequence, the process is simple to operate, while built-in diagnostics warn of an open lid, low fluid level or a blocked drain.