Active USB 2.0 extension Axagon ADR-215B cable, 15 m long.
The USB repetition cable enhances the passing USB signal and allows you to connect a USB device, which is well farther than 10 meters, when passive cables are in use. You can connect multiple repetition cables in a row.
One of the major benefits of the ADR-2110 extension is the built-in network connector. In most cases, the current provided by the USB bus proves to be sufficient, but it may be weak for devices with higher consumption, but this is solved by external power.
Extremely compact size allows you to incorrectly install electrical cables or cable systems.
A high quality shielded cable provides fast communication speed and minimizes unwanted noise.

Properties:

-Fully compatible with USB 2.0 and backwards compatible with USB 1.1.
- Supports the following transmission speeds: 1.5 / 12/480 Mbit / s (Low / Full / High Speed).
- USB TYPE A Dad connector to connect to your computer.
- USB type is the mother connector to connect to a remote USB device.
- Full Plug and Play and Hot Plug support.
- Two LEDs indicate power supply and USB connection.
- The active part dimensions of the USB Type with the mother connector is 65 x 22 x 13 mm and a cable length of 15 m.
- Cable weight: 503 g.
- A common passive USB cable can be used behind the active USB cable.

Power supply:

- The cable and the connected devices are powered by a USB bus (5V - 500mA bus mode).
-Most USB devices are sufficient for the USB bus power and no additional power supply required.
- The active part of the cable contains a connector (Ø 3.5 x 1.3 mm external X internal diameter) to the 5 V / 1-2 for the additional external power supply.
- The power supply is not included, the Axagon AC-5V2A network adapter is recommended.
- When nourishing the reversal cable with the adapter, an outer 2.5 "disk can be connected without needing a power source to the disc.
- Connected with a multiple switch cable for a longer USB route, the USB bus power supply may prove to be inadequate and the additional power provided with a cable can be increased.

Supported operating systems: MS Windows XP / Vista / 7/8 / 8.1 / 10 or later, Windows Server 2003/2008/2012/2016 or higher (all 32 and 64-bit Windows), Mac OS X 10.x or higher, Linux 2.6.x kernels or above.
Note: The drivers are found in operating systems and are completely automatically installed. There is no need to install any other drivers and are not available.