Typical areas of application: mobile and cellular communication tools, telemetry systems, bus and truck, ship, forestry machinery, industrial equipment, etc.The PowerTector battery guard is a semiconductor device that monitors the source voltage and turn off the equipment from the battery if the voltage fall below the specified level. This ensures that there is always sufficient voltage in the battery to start the vehicle and ensures enough energy for other important applications. Since the complete discharge of the lead-acid battery can cause damage to the cells, it can be shortened by the PowerTector unit by switching off the device to a low voltage, which protects the battery from complete discharge, and allows maximum battery use .

Manual dissolution
For units higher than 40A, it is possible to switch off hand switch by ignition. Furthermore, from 100A upwards, units can install an overwriting switch that allows you to turn off the battery guard for a 4-minute duration, re-turning on the devices by performing an emergency action.

Emergency Function (for non -timer type only)
The devices include an alarm output, which will be activated once the voltage reaches the threshold for at least 10 seconds. You will then say or give a signal for 50 seconds that it will disassemble the system. This allows the operator to restart the vehicle or otherwise provide continuous energy.

Full programmability
Each type has pre -programmed voltage levels with higher or lower switching voltages, allowing quick and easy programming to set your unique needs. This prevents the battery from damaging or protecting your key tools.

Wide range of products
The ALPATRONIX POWERTECTOR has 6 different types from 10A to 200a. Units 10A and 20A are simplified products and are usually connected to a specific device. Due to their small size and light weights, these types are not required by their houses as they can be easily installed or directly connected within the wiring system.

Timed versions
In addition to the traditional PowerTector, the PT-T types provide timing instead of the alarm function. After stopping the ignition, turn off the output after a pre -set time. If necessary, during this time, the voltage is monitored by the system and turns it off if it is below a specified level, protecting the battery from deepening. The power supply is reactivated when the ignition starts again and the battery voltage reaches 8.5VDC (12V systems) or 17VDC (24V systems) levels.

Their attachment
The 40A and 60A units can be secured with M6 brass screws, and 100A and 200As are fixed at 3 points, allowing the product to be stable or harmful in electronics, even if Fixing surface is not completely flat. The heat generated by the product is distributed evenly by the self -developed injection molded casing, so it can work with maximum power in the long term without the use of additional heat sinks • The simple programming terminal allows you to use the pre -configured switch according to your expectations.

- You can install an audible alarm and/or a visible mark on the dashboard or cockpit to warn the operator of the current problem.
- The switch terminal allows the unit to be controlled by the ignition or the manual switch.
- The PowerTector battery guard provides a high degree of protection to ensure smooth communication and other vital equipment.
- Every PowerTector product higher than 40A is protected by a durable aluminum cover, which is covered with a polycarbonate house filled with glass to protect the product from heat and ensure insulation.
-Smaller units, versions 10A and 20A, are light polycarbonate coated so that the chassis is not to be drilled.
- switching technology
- compact, lightweight, durable, protected against dust and water (IP65)
- can be used in many industrial applications
- Low resting current (<2 today)
- Stable fixing that allows a simple, fast and safe installation
- thanks to its design extremely low failure ratio
- Life Warranty
- Low heat production can be placed in small, closed spaces without the risk
- Full circuit protection against surge, short circuit and overheating
- Green LED indicates programming, proper operation,